Pavseal

Description:

Cemix® Pavseal is a stain resistant water based penetrating clear weatherproofing sealer. It is based on silane modified nano particle size, self-cross linking hybrid technology and can be effectively used for impregnating and sealing a variety of pavers. It provides adhesion, penetrating and sealing properties on various substrates because of the nano dense self-cross linking particles. There is little or no impairment of the paver’s ability to breathe and exhibits a good MVTR (moisture vapour transmission rate). It can be successfully applied on slightly damp pavers, but surface dry pavers. The application does not produce any discolouration of the surface and is suitable for weatherproofing and sealing a wide variety of absorbent surfaces and not suitable for very dense substrates like marble and granite. It can also be used on timber decks, outdoor furniture, timber wall cladding, clay roof tiles, fibre reinforced cement sheets etc.

Advantages:

  • Environmentally friendly green product
  • Hybrid sealer – penetrates as well as coats
  • Exhibits a high degree of stain resistance
  • Chemically resistant and non toxic
  • UV stable – will not go yellow over time

1L, 4L, 20L and 200L

Substrate Preparation

Ideally this sealer should be applied on new freshly laid pavers. The paver surfaces should be water blasted and made clean, free from grease, loose particles, dirt, paint, curing compounds etc. Moss or algae growth should be removed with a suitable treatment and washed with clean water.

Application:

Shake or stir thoroughly before use.

Always test apply on an area first and approve look and feel.

Cemix® Pavseal should be applied without diluting in two coats to ensure complete coverage and saturation of the paver substrate. Apply with garden sprayer, roller or brush. Depending on the porosity of the pavers – a coverage of approximately 5m2 - 14m2 per litre can be achieved.

Note: There is not a sealer suitable for all types of pavers, tiles, or other surfaces. Never apply more product than is being absorbed into the surface you are sealing. If product is pooling on the surface, brush the excess off. If you feel no product or very little product is being absorbed, stop and seek technical assistance. Always do a test area first to approve the look and feel before doing the entire area. Ensure there is no rising damp as this will make the sealer surface cloudy. Over application can make the surface slippery especially when wet. Thoroughly agitate contents before use.

Technical Data:

Appearance – Milky translucent white emulsion

Application Temp – 5°C - 30°C

Yield / Coverage - 5m2 - 14m2 per litre

Packaging - 1L, 4L, 20L and 200L

Type Anionic, Silane Modified Dispersion

Appearance Milky, translucent white emulsion

Ph 7.5 to 9.0

Density @ 20C 1.06Kg/Lt

Odour Acrylic

The data shown above reflects typical results based on laboratory testing under controlled conditions. Reasonable variations may occur on site.

Limitations:

  • Due to film forming properties, may become slippery in wet areas.

Storage / Shelf Life:

Twelve (12) months when stored in unopened, original containers. Storage area should not be exposed to extreme temperature. Do not expose to direct sunlight in storage.

Cleaning:

Clean all tools with water & brush immediately after use.

Precaution:

Cemix® Pavseal is non-toxic and non-corrosive. If splashed into the eyes, wash eyes with copious amounts of clean water immediately and seek medical attention. If ingested, drink plenty of water and seek medical attention. It is advisable to wear the appropriate safety equipment when spraying this product – goggles, respirator and gloves.