top of page
repair and grouts banner.png
Purple Block.png

DOWNLOADS

SS Fastcrete banner.png
BITUMEN
ROOF & GUTTER REPAIR TAPE .jpg

CEMIX BITUPATCH is a ready to use, cold mix bitumen asphalt, designed for repairing potholes in asphalt roads, driveways and paths. It is simply and easily placed directly from the pail in to the hole.

TYPICAL USES:

• Potholes

• Speed bumps

• Ramps


ADVANTAGES:

• Ready to use

YIELD:

Approximate yield for 20kg pail: 0.01m3


PREPARATION:

Thoroughly clean the area to be filled or reinstated. It should be free of any loose and deleterious materials. All substrates should be structurally sound, securely fastened and properly supported to eliminate any movement that may cause cracking.

For pothole repair, where possible, it is recommended to create a vertical edge to the hole for CEMIX BITUPATCH to butt up against.


APPLICATION:

1. Place CEMIX® BITUPATCH on the area to be repaired. When repairing potholes, ensure the middle of the placed product is higher than the sides, by 5mm to 10mm depending on the repair area size. This will counteract subsidence caused by compacting.

2. Compact the hole. For best results, use a compacting plate or steel wheel roller. For smaller areas, use a large flat material, such as a timber post, compressed with a rubber mallet or similar.

CEMIX® BITUPATCH can be applied between 5°C to 30°C.

However, for best results, use between 21°C to 30°C.


DRYING & CURING:

Drying time depends on the climate.

Supplier Item#

20 KG - 25214

Download the Data Sheet for full information:

bottom of page