SUBSTRATE TEST:

The concrete substrate must be absorbent or porous. Test this by sprinkling water on the surface. If the water readily soaks into the concrete, the surface is suitable for application. If the water beads on the surface, the concrete is not suitable for application and any previous coatings need to be removed.

MIXING:

· Add clean water to a mixing container. Use approximately 200ml of water per kg of product.

· Add CEMIX EASYFLOR slowly to the water, mixing constantly with a mixing paddle, until a smooth consistency is achieved

Note: Only mix as much product as can be used within 20 minutes. Do not aerate the mixture by stirring over vigorously or for too long.

APPLICATION:

1. Pour the mixture onto the surface immediately after mixing - it should be in a slurry form.

2. When a screed of uniform bed thickness is required, move it across the surface at a constant speed.

3. Levels may be corrected by applying a greater or lesser amount of mixture.

4. The semi-hardened material may easily be formed or cut, allowing any necessary adjustments to be made.

CEMIX EASYFLOR can be applied at a bed thickness between 3mm to 6mm. A depth greater than 6mm can be acheived by applying multiple coats.

Note: Honour any expansion and control joints.

DRYING & CURING:

Drying and curing time depends on the substrate, substrate condition, climate, the type of application and the materials being applied. Allow a minimum of 24 hours at 20°C, before commencing further work or trafficking