Cemix Products Ltd logo

decorative sealers

PAVSEAL

USER CATEGORY :

DIY TRADES COMMERCIAL

Packaging

  • 1L
  • 4L
  • 20L
  • 200L

PRODUCT INFORMATION & RESOURCES

DESCRIPTION

CEMIX PAVSEAL is a stain resistant water based penetrating and film forming clear weatherproofing sealer. It is based on silane modified nano particle size, self-cross linking hybrid technology and can be effectively used for impregnating and sealing a variety of pavers. It provides adhesion, penetrating and sealing properties on various substrates because of the nano dense self-cross linking particles. There is little or no impairment of the paver’s ability to breathe and exhibits a good MVTR (moisture vapour transmission rate). It can be successfully applied on slightly damp pavers, but surface dry pavers. The application does not produce any discolouration of the surface and is suitable for weatherproofing and sealing a wide variety of absorbent surfaces and not suitable for very dense substrates like marble and granite. It can also be used on timber decks, outdoor furniture, timber wall cladding, clay roof tiles, fibre reinforced cement sheets etc.

TYPICAL APPLICATION/USES

  • For sealing a variety of pavers
  • It can also be used on timber decks, outdoor furniture, timber wall cladding, clay roof tiles, fibre reinforced cement sheets etc

ADVANTAGES

  • Environmentally friendly green product
  • Hybrid sealer – penetrates as well as coats (thin film).
  • Exhibits a high degree of stain resistance
  • Chemically resistant and non toxic
  • UV stable – will not go yellow over time

SUBSTRATE PREPARATION

Ideally this sealer should be applied on new freshly laid pavers. The paver surfaces should be water blasted and made clean, free from grease, loose particles, dirt, paint, curing compounds etc. Moss or algae growth should be removed with a suitable treatment and washed with clean water.

APPLICATION

Shake or stir thoroughly before use. Always test apply on an area first and approve look and feel. CEMIX PAVSEAL should be applied without diluting in two coats to ensure complete coverage and saturation of the paver substrate. Apply with garden sprayer, roller or brush. Depending on the porosity of the pavers – a coverage of approximately 5m² – 14m² per litre can be achieved.

GOLDEN RULE

There is no one sealer for all types of surfaces. The golden rule is to never apply more product than is being absorbed into the surface you are sealing. If product is pooling on the surface, brush the excess off. Do not let product pool on surface as this can result in excessive build up which is difficult to remove.If you feel no product or very little is being absorbed, stop, and seek technical advice from CEMIX. Always do a small test area first and approve look and feel.

TECHNICAL DATA

Appearance – Milky translucent white emulsion
Application Temp – 5°C – 30°C
Yield / Coverage – 5m² – 14m² per litre
Packaging – 1L, 4L, 20L and 200L
Type Anionic, Silane Modified Dispersion
Appearance Milky, translucent white emulsion
Ph 7.5 to 9.0
Density @ 2°C 1.06Kg/Lt
Odour Acrylic
The data shown above reflects typical results based on laboratory testing under controlled conditions. Reasonable variations may occur on site.

LIMITATIONS

Due to film forming properties, may become slippery in wet areas.

STORAGE / SHELF LIFE

Twelve (12) months when stored in unopened, original containers. Storage area should not be exposed to extreme temperature. Do not expose to direct sunlight in storage.

CLEANING

Clean all tools with water & brush immediately after use.

product Videos

Visit our more videos

View More

Related Videos