PREPARATION:

The substrate should be free of dust, grease, wax, oil, dirt, loose plaster, laitance, curing compounds, paint and all other friable materials and contaminants likely to prevent sealing and coating.

Ideally, CEMIX POTTERY SEALER should be applied to new pottery. If applying to existing work, it is recommended to remove any stains, marks, variations etc. from the substrate before application, as the product is likely to magnifiy these.

Ensure that the substrate is dry before application.

Always carry out a small test area to approve look and feel.

APPLICATION:

1. Shake before use.

2. Apply the product straight from the spray bottle.

The sealer will dry in approximately 20 minutes at 25°C. Further coats may be required for more porous substrates. If a more satin finish is preferable, build up coats (as required).

DRYING & CURING TIME:

Drying and curing time may vary depending on the substrate and climate. Drying time is approximately 4 hours. Curing time is up to approximately 48 hours.

CLEANING:

Clean tools with water immediately after use.

STORAGE & SHELF LIFE:

Up to 12 months when stored in the original, unopened packaging, in a dry place at 23°C and 50% relative humidity.

LIMITATIONS:

Do not apply if rain is expected within 48 hours.

Not to be used as a waterproofer.

CEMIX POTTERY SEALER is likely to darken and/or discolour the surface. Carry out a small test area first.

Environmental conditions may affect the product’s performance over time. Reapplication may be required after two years or more from initial application, depending on these conditions.

If your project requires Building Consent, please email info@cemix.co.nz about the suitability of this product before use.