top of page
repair and grouts banner.png
Purple Block.png

DOWNLOADS

SS Fastcrete banner.png
UNDERTILE WATERPROOFING SYSTEM
ROOF & GUTTER REPAIR TAPE .jpg

CEMIX RUBBERGUARD PEEL & SEAL TAPE is a self adhesive tape designed to reinforce straight and right angled joints, over cementitious and plasterboard surfaces. It is used as part of the CEMIX RUBBERGUARD waterproofing system.

TYPICAL USES:

For reinforcing straight and right angled joints in conjunction with the CEMIX RUBBERGUARD system. Suitable for interior use.


ADVANTAGES:

• Instant sealing

YIELD:

5 linear metres


STANDARDS:

BRANZ appraised when used as part of the the CEMIX RUBBERGUARD waterproofing system.

PREPARATION: The substrate should be free of dust, grease, wax, oil, dirt, loose plaster, laitance, curing compounds, paint and all other friable materials and contaminants likely to prevent bonding.

New concrete should be left with a wood float finish and sufficiently aged as per manufacturer’s recommendations.

All substrates should be structurally sound, securely fastened and properly supported to eliminate any movement that may cause cracking.

It is recommended to prime the surface with CEMIX TILE BOND LATEX to stabilise the surface.

After priming, it is recommended to apply a neutral, cure sealant to all wall and floor junctions and joints.


APPLICATION:

1. Unroll and cut CEMIX RUBBERGUARD PEEL & SEAL TAPE to the required length, using scissors or a sharp cutter knife.

2. Place the tape over the area to be sealed and while slowly unwinding, remove the release paper and position the tacky side directly over the area to be sealed. It is not recommended to remove the total length of the release paper before adhering the tape into position.

3. Press the tape into position with a spatula, roller or cloth, ensuring air pockets and creases are removed.

Supplier Item#

21142

Download the Data Sheet for full information:

Anchor 1
bottom of page