top of page
repair and grouts banner.png
Purple Block.png

DOWNLOADS

SS Fastcrete banner.png
TILE ADHESIVES
ROOF & GUTTER REPAIR TAPE .jpg

CEMIX WALLSET TILE ADHESIVE is a premium, flexible, polymer modified, water resistant, white cement based tile adhesive, used for fixing a wide range of tiles onto a variety of substrates.

TYPICAL USES:

CEMIX WALLSET TILE ADHESIVE can be used on concrete, cement renders, screeds, fibrous cement sheeting, plasterboard and CEMIX 

approved waterproofing membranes. Suitable for use in interior and exterior wall and floor applications, including bathrooms, toilets, laundries, kitchens, decks and verandahs.


ADVANTAGES:

• Excellent non-slump properties • Water resistant

• Complies with C1TES1

YIELD:

Varies according to the substrate condition and trowel size.

Approximates per kg of product using a notched trowel sized: 6mm: 0.85m², 10mm: 0.60m²


STANDARDS:

All workmanship must be carried out in accordance with AS3958.1.


PREPARATION:

The substrate should be free of dust, grease, wax, oil, dirt, loose plaster, laitance, curing compounds, paint and all other friable materials and contaminants likely to prevent the adhesive bonding.


New concrete should be left with a wood float finish and sufficiently aged as per manufacturer's recommendations.


All substrates should be structurally sound, securely fastened and properly supported to eliminate any movement that may cause cracking.


CEMIX screeds, floor levellers, plasters and approved water- proofing membranes must be allowed to cure.


It is recommended to prime the surface with a CEMIX TILE BOND LATEX before the application of CEMIX WALLSET WHITE TILE ADHESIVE.


CEMIX WALLSET WHITE TILE ADHESIVE is also suitable for tiling over timber floors, provided that a fibre cement sheet tile underlay is initially installed over the timber floor.


MIXING:

1. Add clean water to a mixing container. Use approximately 200ml to 300ml of water per kg of product.

2. Add CEMIX WALLSET WHITE TILE ADHESIVE slowly to the water, mixing constantly with a mixing paddle, until a creamy consistency is achieved.

3. Allow to stand for 5 minutes. 4. Remix.


Note: Do not aerate the mixture by stirring over vigorously or for too long. The mix should be stiff enough to keep its shape when spread with a notched trowel.


APPLICATION:

1. Spread the mixture evenly overly the surface with a suitably sized notched trowel.

2. Install the tiles with pressure, twisting to ensure good adhesion between the substrate and tile.

In more demanding situations, it is preferable to also spread the back of the tiles with a thin layer of mixture.

Supplier Item#

20 KG

Download the Data Sheet for full information:

Anchor 1
bottom of page